Filter
Top Products
3 - 41
CHK
ADJ
CHANGING THE ENGINE OIL/
MEASURING THE ENGINE OIL PRESSURE
13.Check:
• engine oil pressure
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Slightly loosen the oil gallery bolt 1.
b. Start the engine and keep it idling until
engine oil starts to seep from the oil gallery
bolt. If no engine oil comes out after one
minute, turn the engine off so that it will not
seize.
c. Check the engine oil passages, the oil filter
cartridge and the oil pump for damage or
leakage. Refer to “OIL PAN AND OIL
PUMP” in chapter 5.
d. Start the engine after solving the problem(s)
and check the engine oil pressure again.
e. Tighten the oil gallery bolt to specification.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
T
R
.
.
Oil gallery bolt
20 Nm (2.0 m · kg)
EAS00077
MEASURING THE ENGINE OIL PRESSURE
1. Check:
• engine oil level
Below the minimum level mark → Add the
recommended engine oil to the proper level.
2. Remove:
• side cowlings
3. Start the engine, warm it up for several min-
utes, and then turn it off.
CAUTION:
@
When the engine is cold, the engine oil will
have a higher viscosity, causing the engine
oil pressure to increase. Therefore, be sure
to measure the engine oil pressure after
warming up the engine.