Filter
Top Products
6 - 17
COOL
WATER PUMP
4. Measure:
• impeller shaft tilt
Out of specification → Repeat steps (3) and
(4).
CAUTION:
@
Make sure the rubber damper and rubber
damper holder are flush with the impeller.
1
Straightedge
2
Impeller
Max. impeller shaft tilt
0.15 mm
5. Install:
• impeller
1
•circlip
NOTE:
@
After installation, check that the impeller shaft
rotates smoothly.
New
6. Install:
• O-ring
NOTE:
@
Lubricate the O-ring with a thin coat of lithium
soap base grease.
New
7. Install:
• water pump housing
• water pump housing cover
WARNING
Always use a new copper washer.
T
R
.
.
10 Nm (1.0 m · kg)