Filter
Top Products
3 - 39
CHK
ADJ
CHANGING THE ENGINE OIL
EAS00073
CHANGING THE ENGINE OIL
1. Start the engine, warm it up for several min-
utes, and then turn it off.
2. Place a container under the engine oil drain
bolt.
3. Remove:
• engine oil filler cap
1
• engine oil drain bolt
2
(along with the gasket)
4. Drain:
• engine oil
(completely from the crankcase)
5. If the oil filter cartridge is also to be
replaced, perform the following procedure.
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Remove the left side cowling.
Refer to “COWLINGS AND COVERS”.
b. Remove the oil filter cartridge
1
with an oil
filter wrench
2
.
c. Lubricate the O-ring
3
of the new oil filter
cartridge with a thin coat of engine oil.
CAUTION:
@
Make sure the O-ring
3
is positioned cor-
rectly in the groove of the oil filter car-
tridge.
d. Tighten the new oil filter cartridge to specifi-
cation with an oil filter wrench.
e. Install the left side cowling.
Refer to “COWLINGS AND COVERS”.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
Oil filter wrench
90890-01426
T
R
.
.
Oil filter cartridge
17 Nm (1.7 m · kg)