Filter
Top Products
4 - 75
CHAS
HANDLEBARS
4. Install:
• brake master cylinder
• brake master cylinder holder 1
NOTE:
@
• Install the brake master cylinder holder with
the “UP” mark facing up.
• First, tighten the upper bolt, and then the
lower bolt.
• Align the mating surfaces of the brake mas-
ter cylinder holder with the punch mark a in
the right handlebar.
T
R
.
.
10 Nm (1.0 m · kg)
5. Install:
• handlebar grip
• grip end
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Apply a thin coat of rubber adhesive onto
the left end of the left handlebar.
b. Slide the handlebar grip over the left end of
the left handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
WARNING
@
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
NOTE:
There should be 1 ~ 3 mm of clearance a
between the throttle grip and the grip end.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
T
R
.
.
4 Nm (0.4 m · kg)
6. Install:
• left handlebar switch 1
NOTE:
@
Align the projection a on the left handlebar
switch with the hole b in the left handlebar.