Filter
Top Products
4 - 41
CHAS
FRONT AND REAR BRAKES
3. Install:
• brake pads
• brake pad spring
• brake caliper
• brake hose holder
Refer to “REPLACING THE FRONT
BRAKE PADS”.
T
R
.
.
40 Nm (4.0 m · kg)
T
R
.
.
7 Nm (0.7 m · kg)
4. Fill:
• brake master cylinder reservoir
(with the specified amount of the recom-
mended brake fluid)
WARNING
@
• Use only the designated brake fluid.
Other brake fluids may cause the rubber
seals to deteriorate, causing leakage and
poor brake performance.
• Refill with the same type of brake fluid
that is already in the system. Mixing
brake fluids may result in a harmful
chemical reaction, leading to poor brake
performance.
• When refilling, be careful that water does
not enter the brake master cylinder reser-
voir. Water will significantly lower the
boiling point of the brake fluid and could
cause vapor lock.
CAUTION:
@
Brake fluid may damage painted surfaces
and plastic parts. Therefore, always clean
up any spilt brake fluid immediately.
5. Bleed:
• brake system
Refer to “BLEEDING THE HYDRAULIC
BRAKE SYSTEM” in chapter 3.
Recommended brake fluid
DOT 4