Filter
Top Products
4 - 89
CHAS
SWINGARM
EAS00702
REMOVING THE SWINGARM
1. Stand the motorcycle on a level surface.
WARNING
@
Securely support the motorcycle so that
there is no danger of it falling over.
NOTE:
@
Place the motorcycle on a suitable stand so
that the rear wheel is elevated.
2. Measure:
• swingarm side play
• swingarm vertical movement
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Measure the tightening torque of the swin-
garm pivot shaft, pivot shaft nut and locknut.
b. Measure the swingarm side play
È
by mov-
ing the swingarm from side to side.
c. If the swingarm side play is out of specifica-
tion, check the spacers, bushing and bear-
ings.
d. Check the swingarm vertical movement
É
by moving the swingarm up and down.
If swingarm vertical movement is not
smooth or if there is binding, check the
spacers, bushing and bearings.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
T
R
.
.
Pivot shaft nut
125 Nm (12.5 m · kg)
Locknut
115 Nm (11.5 m · kg)
Pivot shaft
7 Nm (0.7 m · kg)
Swingarm side play (at the end of
the swingarm)
0 mm
EAS00707
CHECKING THE SWINGARM
1. Check:
• swingarm
Bends/cracks/damage
→
Replace.