3 - 17
CHK
ADJ
ADJUSTING THE VALVE CLEARANCE
É Degrees that the crankshaft is turned counter-
clockwise
Ê Cylinder
Ë Combustion cycle
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
5. Remove:
• rubber plug
1
• timing chain tensioner cap bolt
2
• gasket
Cylinder #2 180°
Cylinder #4 360°
Cylinder #3 540°
6. Turn the timing chain tensioner rod fully
clockwise with a thin screwdriver
1
.
NOTE:
Make sure that the tensioner rod has been fully
set clockwise.
7. Remove:
• intake camshaft caps
• exhaust camshaft caps
• timing chain
(from the camshaft sprockets)
• intake camshaft
• exhaust camshaft
NOTE:
@
• Refer to “CAMSHAFTS” in chapter 5.
• When removing the timing chain and cam-
shafts, fasten the timing chain with a wire to
retrieve it if it falls into the crankcase.
8. Adjust:
• valve clearance
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Remove the valve lifter
1
and the valve pad
2
with a valve lapper
3
.
Valve lapper
90890-04101