Filter
Top Products
5 - 78
ENG
7. Select:
•shim(s) 1
▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼ ▼▼▼▼ ▼▼▼
a. Shims can only be selected in 0.05 mm
increments, therefore round off to the hun-
dredth’s digit of the calculated thickness
and select the appropriate shim with the fol-
lowing chart.
b. For example, the clearance between the
crankcase and the middle driven shaft bear-
ing housing is 0.42 mm. Therefore, the
chart instructs you to round off the 2 to 0.
Thus, you should use one 0.40 mm shim.
Shims are supplied in the following thick-
nesses.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
Hundredth Rounded value
0, 1, 2 0
3, 4, 5, 6, 7 5
8, 9 10
Middle driven pinion gear shim
Thickness (mm)
0.10 0.15 0.30
0.40 0.50 0.60
8. Loosen:
• middle driven shaft bearing housing bolts
9. Install:
•shim(s)
10.Tighten:
• middle driven shaft bearing housing bolts
11.Measure:
• middle gear backlash
Out of specification → Refer to “MEASUR-
ING THE MIDDLE GEAR BACKLASH”.
T
R
.
.
25 Nm (2.5 m · kg)
MIDDLE GEAR