Filter
Top Products
5 - 22
ENG
CYLINDER HEAD
d. Loosen and retighten the cylinder head
bolts in the proper tightening sequence as
shown.
T
R
.
.
Cylinder head bolt (M10)
2nd
25 Nm (2.5 m · kg)
e. Tighten the cylinder head bolts further to
reach the specified angle 180° in the proper
tightening sequence as shown.
WARNING
When the bolts are tightened more than the
specified angle, do not loosen the bolt and
then retighten it.
Replace the bolt with a new one and per-
form the procedure again.
CAUTION:
• Do not use a torque wrench to tighten the
bolt to the specified angle.
• Tighten the bolt until it is at the specified
angle.
NOTE:
When using a hexagonal bolt, note that the
angle from one corner to another is 60°.
▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲ ▲▲▲▲ ▲▲▲
T
R
.
.
Cylinder head bolt (M10)
Final
Specified angle 180°