Filter
Top Products
5 - 48
ENG
EAS00275
EAS00277
REMOVING THE CLUTCH
1. Remove:
• rear balancer weight
Refer to “BALANCERS”.
2. Remove:
•clutch cover
1
NOTE:
@
Loosen each bolt 1/4 of a turn at a time, in
stages and in a crisscross pattern. After all of
the bolts are fully loosened, remove them.
3. Straighten the lock washer tab.
4. Loosen:
• clutch boss nut
1
NOTE:
@
While holding the clutch boss
2
with the uni-
versal clutch holder
3
, loosen the clutch boss
nut.
Universal clutch holder
90890-04086
5. Remove:
• clutch boss nut
1
• lock washer
2
• clutch boss assembly
3
NOTE:
@
There is a built-in damper between the clutch
boss and the clutch plate. It is not necessary to
remove the wire circlip
4
and disassemble the
built-in damper unless there is serious clutch
chattering.
CLUTCH