Filter
Top Products
2.23
MAINTENANCE
2
Engine Oil Level
The oil tank is located on the left side of the vehicle. To check
the oil level:
1. Set machine on a level surface.
2. Clean the area around the dip stick.
3. Start and run engine for 20-30 seconds. This will return oil
to its true level in the oil tank.
4. Stop engine, remove dipstick (A) and wipe dry with a clean
cloth.
5. Reinstall dipstick, screw the dipstick into place.
NOTE: The dipstick must be screwed completely in to
ensure accurate measurement.
6. Remove dipstick and check to see that the oil level is in the
normal range. The oil should be between the top line and
the bottom line on the dipstick. Add oil as indicated by the
level on the dipstick. Do not overfill.
NOTE: Rising oil level between checks in cool weather
driving, can indicate moisture collecting in the oil
reservoir. If the oil level is over the full mark, change the
oil.
Oil and Filter Change
NOTICE: Care must be taken to ensure that the fluids are
contained. Be prepared to collect the fluid with suitable
containers before opening any compartment or disassembly of
any component containing fluids.
1. Place vehicle on a level surface.
2. Clean area around drain plug (A) at bottom of oil tank.
3. Run engine two to three minutes until the engine is warm.
4. After two or three minutes stop the engine.
A
ADD 8 OZ.
NORMAL
FULL
Maintain Oil Level In Normal range
Screw Dipstick in completely to check
Oil Filter Torque:
Turn by hand until filter gasket
contacts sealing surface, then
turn an additional 1/2 turn
Oil Filter Wrench:
(PV-43527)
Oil Tank Screen Fitting Torque:
25 ft-lb (34Nm)
Recommended Engine Oil:
Polaris Premium 4 All Season
Synthetic, 0W-40
WARNING
Personal injury can occur when handling used
oil. Hot oil can cause burns or skin damage.