Filter
Top Products
10.41
ELECTRICAL
10
3. X2 and Sportsman - Carefully pull out the red locking tab
on the connector.
4. X2 and Sportsman - Once the red tab is pulled out, press
in on the black tab and pull out to disconnect harness.
5. X2 and Sportsman - Disconnect the two wire harnesses
connected to each of the taillights. Twist bulb housing to
remove from lamp assembly and replace bulb.
Brake Light Switch Test
1. Remove the front cover.
2. Disconnect wire harness from switch.
3. Connect an ohmmeter across switch contacts. Reading
should be infinite (
.
4. Apply brake at handlebar lever and check for continuity
between switch contacts. Replace switch if there is no
continuity or greater than .5 ohms resistance when the brake
is applied with slight pressure.
Black Tab
Red Tab
Remove
Install
Brake Lamp Switch
Brake Switch
Location