Filter
Top Products
2-13190-01102-02 Rev. B
Garmin G500 Pilot’s Guide
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary Appendix A
Appendix B
Index
2.5 Vertical Speed (V/S) Indicator
Vertical speed data is presented on the bottom right of the PFD. A Vertical
Speed bug and a bug setting are also available.
Current Vertical Speed
Vertical Speed Bug
Vertical Speed Bug Setting
Figure 2-22 Vertical Speed (V/S) Tape and Window
The Vertical Speed Indicator displays the aircraft vertical speed using a non-
moving tape. The tape can be scaled at ±2000, ±3000, or ±4000 fpm as set by
the installer. Major gradations are every 1000 fpm and minor gradations every
500 fpm. The current vertical speed is displayed in the pointer along the tape.
Digits appear in the pointer when the climb or descent rate is greater than 100
fpm. If the rate of ascent/descent exceeds the vertical speed displayed on the
tape, the pointer appears at the corresponding edge of the tape and the rate
appears inside the pointer. The Vertical Speed Indicator range determines the
airspeed tape range.
VSI (set by installer) Airspeed Tape Range
±2000 fpm 60 kts
±3000 fpm 70 kts
±4000 fpm 80 kts
Table 2-1 Vertical Speed Settings
Setting the Vertical Speed Indicator Bug
1) Press the V/S key to activate Vertical Speed mode.
2) Turn the PFD knob to change the Vertical Speed Bug.
3) Press the center of the PFD knob to set the Vertical Speed value to the current
vertical speed.