Filter
Top Products
3-55190-01102-02 Rev. B
Garmin G500 Pilot’s Guide
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary Appendix A
Appendix B
Index
4) Turn the small MFD knob to select the desired data item and press ENT.
5) Press the small MFD knob to remove the cursor.
To restore factory default settings for data fields on the Active Flight Plan
Page:
1) While viewing the Active Flight Plan Page of the FPL page group, press MENU
to display the Active Flight Plan Page Options window.
2) Turn the large MFD knob to highlight “Restore Defaults?” and then press
ENT.
Figure 3-83 Active Flight Plan Page Menu Option Selection to Restore Defaults
3.5.1.3 Setting the Altitude Minimums Alerter
1) While viewing the Active Flight Plan Page of the FPL page group, press the
small MFD knob. Turn the large MFD knob to activate the Altitude Minimums
Alerter.
2) Turn the large and small MFD knobs to change the Altitude Minimums value.
Resolution is ten feet.
Figure 3-84 Barometric Minimums Altitude Selection
3) Press ENT to activate the selected value.
Alerting is inhibited while the aircraft is on the ground and until the aircraft
reaches 150 feet above the MDA. The Minimum altitude will be available in the
Altitude Alerter.
In dual installations, the minimums alerting altitude value may be set from
either GDU 620 and will be synchronized on both units.
NOTE: If you highlight the Minimums Altitude field on the FPL page and press the CLR
key, it will turn the minimums functionality off.