Filter
Top Products
4-76
Garmin G500 Pilot’s Guide
190-01102-02 Rev. B
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
GlossaryAppendix A
Appendix B
Index
Figure 4-66 Vertical Scan Display
4.8.6.2 Vertically Scanning a Storm Cell
NOTE: Vertical scanning of a storm cell should be done with the aircraft
wings level to avoid constant adjustment of the Bearing Line.
1) While in the Horizontal Scan view, press the CONTROL and then the BRG soft
keys. This displays the Bearing Line.
OR
Press MENU and turn the large or small MFD knobs to highlight the “Show
Bearing Line” menu item and press the ENT key. This displays the Bearing
Line.
2) Press the MFD knob to activate the Bearing Line Adjustment in the Control
window. Turn the Large MFD knob to highlight the Bearing value.
3) Turn the small
MFD knob to place the Bearing Line on the desired storm cell or
other area to be vertically scanned.