Filter
Top Products
1-9190-01102-02 Rev. B
Garmin G500 Pilot’s Guide
Foreword
Sec 1
System
Sec 2
PFD
Sec 3
MFD
Sec 4
Hazard
Avoidance
Sec 5
Additional
Features
Sec 6
Annun.
& Alerts
Sec 7
Symbols
Sec 8
Glossary Appendix A
Appendix B
Index
Inserting an SD Card
1) Insert the SD card in the SD card slot (the front of the card should be flush with
the face of the display bezel).
2) To eject the card, gently press on the SD card to release the spring latch.
1.1.14 Pilot Controls
The GDU 620 controls have been designed to simplify operation of the
system and minimize workload and the time required to access sophisticated
functionality. Controls are located on the PFD and MFD bezels and are comprised
of a PFD knob, MFD dual concentric knobs, bezel keys, and soft keys.
1.1.14.1 PFD Knob
Turning the PFD knob adjusts the values for the mode selected by the PFD
bezel keys, such as, Heading (HDG), Course (CRS), Altitude (ALT), Vertical
Speed (V/S), and Barometric Setting (BARO). The values are shown in a window
to the left of the HSI. Pressing the PFD knob reverts to the default value of the
selected mode.
Heading
Mode
Course
Mode
Altitude
Mode
Vertical Speed
Mode
Barometer
Mode
Figure 1-12 Selection Modes Adjusted with the PFD Knob
NOTE: After 10 seconds of inactivity in another mode, the PFD knob
selected mode will revert to Heading mode.
1. Press the desired PFD mode selection key (HDG, CRS, ALT, V/S, or BARO). A
window will be displayed near the upper right corner of the HSI showing the
current value for that mode.
2. Turn the PFD knob to select the desired value.