Filter
Top Products
Section
7-1
7 Options
The options available for the Model 8800C Flowmeter are described in
this section. The numbers in parentheses refer to the codes used to
order each option.
SAFETY MESSAGES Instructions and procedures in this section may require special
precautions to ensure the safety of the personnel performing the
operations. Please refer to the following safety messages before
performing any operation in this section.
LCD INDICATOR The LCD indicator (option code M5) provides local indication of the
output and abbreviated diagnostic messages governing operation of the
flowmeter. The indicator is located on the circuit side of the flowmeter
electronics, leaving direct access to the signal terminals. An extended
cover is required to accommodate the indicator. Figure 7-1 shows the
flowmeter fitted with the LCD indicator and extended cover.
Explosions could result in death or serious injury:
• Do not remove the transmitter cover in explosive atmospheres when the
circuit is live.
• Before connecting a F
OUNDATION fieldbus-compliant host in an explosive
atmosphere, make sure the instruments in the loop are installed in accordance
with intrinsically safe or non-incendive field wiring practices.
• Verify that the operating atmosphere of the transmitter is consistent with the
appropriate hazardous locations certifications.
• Both transmitter covers must be fully engaged to meet explosion-proof
requirements.
Failure to follow these installation guidelines could result in death or serious injury:
• Make sure only qualified personnel perform the installation.