Filter
Top Products
D-9
Operation with Fisher-Rosemount
®
DeltaV™
The TRANSDUCER BLOCK PROPERTIES dialog box appears (see
Figure D-14).
Figure D-14. TRANSDUCER BLOCK
PROPERTIES Dialog Box.
5. Click the MODE tab.
6. Select the OUTOFSERVICE (OOS) check box and deselect the
AUTO check box in the TARGET MODE column of the dialog box.
The parameters you change in the TRANSDUCER BLOCK
PROPERTIES dialog box remain highlighted (as in Figure D-14) so you
can easily track changes.
7. Click APPLY to apply the changes you made.
NOTE
The software warns you that the changes you made may upset the
process and create a dangerous situation in your plant (see
Figure D-15). Verify that the control loop is in manual control before
proceeding.
Figure D-15. TRANSDUCER BLOCK
PROPERTIES Dialog Box.
8. Click OK.
ÿÿ