Filter
Top Products
3 - DIRECT-TO
66
190-00356-00 Rev E
Selecting Direct-To a Holding Pattern
YoumayselectaDirect-Tocoursetoaholdingpat-
tern that is in your flight plan.
To set a direct-to course to a holding pattern:
1. Press the FPL key to reach the active flight plan
page.
2. Press the small right knob to activate the
cursor. Turn the large right knob to highlight
the hold leg of the flight plan.
3. Press direct-to. “Activate” will be highlighted.
Press ENT to activate a course Direct-To the
holding pattern. Or, press CLR to cancel the
process.
4. The holding pattern waypoint will now be set
as the direct-to waypoint.