Filter
Top Products
11 - MESSAGES
ABBREVIATIONS &
NAV TERMS
183
190-00356-00 Rev E
COM transmitter power has been reduced — (GNS
430W/GNC 420W only) Excessive unit temperature and/or
an insufficient voltage level has been detected. The COM
transceiver transmit power has been automatically reduced
to compensate for the condition. For excessive tempera-
tures, check for adequate ventilation or check cooling air
flow. If the message persists, contact your Garmin dealer for
assistance.
Configuration error - Config service req’d — The con-
figuration information provided by the installer has been
lost or corrupted. Contact your Garmin dealer for service.
Data transfer cancelled (crossfill is busy) — An
attempt to transfer flight plan data during a unit-to-unit
crossfill was cancelled. The host unit is busy. Wait until
any previous crossfill operation is complete, before re-
attempting the transfer.
Data transfer cancelled (data invalid) — An attempt
to transfer a single user waypoint during a unit-to-unit
crossfill was cancelled. No waypoint was specified on the
Crossfill Page. Select a user waypoint and re-attempt the
transfer.
Data transfer cancelled (version mismatch) — An
attempt to transfer data during a unit-to-unit crossfill was
cancelled. The database versions of the two 400W-series
unit are not identical. If necessary, update the database(s)
so they match. Contact Jeppesen or your Garmin dealer for
assistance.
Data transfer error, please re-transmit — An error was
detected during unit-to-unit crossfill of user data (user
waypoints and/or flight plans). The data transfer should be
re-attempted.
Data transfer is complete — The unit-to-unit crossfill of
all user waypoint data has finished.
Database changed, validate user modified procedures
— You have modified one or more approaches, departures
or arrivals from their original published form. When the
NavData
®
card is replaced (database update), you must
manually verify your changes in the new database. This
message occurs each time a flight plan containing a modi-
fied procedure (generated from a prior database version) is
activated. To eliminate the message, re-create the flight plan
from the new database, then make the desired modific-
ations.
Display backlight failure — The 400W-series unit has
detected a failure in the display backlighting. The unit
should be taken to your Garmin dealer for service.
Do not use for navigation — The 400W-series unit is in
DemoModeandmustnotbeusedforactualnavigation.
FPL has been truncated — The flight plan (FPL) was
truncated because not enough room existed to insert an
approach, departure or arrival. This may occur upon
power up when a database change increases the number of
waypoints within an instrument procedure.
FPL is full — remove unnecessary waypoints — An
attempt has been made to add more than 31 waypoints to
a flight plan (FPL). The 400W-series unit does not allow
more than 31 waypoints per flight plan.
FPL waypoint is locked — At least one flight plan (FPL)
waypoint is locked because the waypoint has been removed
fromthecurrentNavData
®
card (database change), the data
card is missing, or the data card has failed.
FPL waypoint moved — The position data for one or
more flight plan (FPL) waypoints moved at least 0.33 arc
minutesinthecurrentNavData
®
card (database change).
G/S has failed — (GNS 430W only) A failure in the
glideslope receiver has been detected. The glideslope
receiver is not available and the unit should be returned to
your Garmin dealer for service.