Filter
Top Products
2 Touch [3D Calibration Status].
The “3D Calibration Status” screen appears.
2
3
4
5
1
6
7
1 Speed
The speed detected by the navigation sys-
tem is indicated. (This indication may be
different from the actual speed of your vehi-
cle, so please do not use this instead of the
speedometer.)
2 Acceleration or deceleration/Rotational
speed
Acceleration or deceleration velocity of your
vehicle is indicated. Also, rotational speed
when your vehicleturns to left or right is
shown.
3 Distance
Driving distance is indicated.
4 Speed Pulse
Totalnumber of speed pulses is indicated.
5 Learning Status
Current driving mode is indicated.
6 Inclination
Degree of slope of the street that you are
currently running is indicated.
7 Degree of learning
Sensor learning situations for distance
(Distance), right turn (Right Turn), left turn
(Left Turn) and 3D detection (3D) are indi-
cated by the length of bars.
p When tires have been changed or
chains fitted, turning on the Speed
Pulse allows the system to detect the
fact that the tire diameter has changed,
and automatically replaces the value for
calculating distance.
p If ND-PG1 is connected, the distance
calculation value cannot be replaced
automatically.
Clearing status
You can delete the learned results stored in
[Distance], [Speed Pulse]or[Learning Sta-
tus].
1 Touch [Distance] or [Speed Pulse].
The following message appears.
2 Touch [Yes].
Clears the learned results stored in [Distance]
or [Speed Pulse].
3 Touch [Learning Status].
The following message appears.
4 Touch [All].
Clears all learning statuses.
p Touch[All] for the following cases:
— After changing the installation position
of the navigation system
— After changing the installation angle of
the navigation system
— After moving the navigation system to
another vehicle
# Touch [Distance].
Clears the learned results stored in [Distance].
p When the distance accuracy is low, touch
[Distance].
Customizing preferences
En
93
Chapter
13
Customizing preferences