Pioneer AVIC-Z110BT GPS Receiver User Manual


 
Messages and how to react to them
The following messages may be displayed by your navigation system. Refer to the table below to
identify the problem, then take the suggested corrective action.
There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Messages and how to react to them
Message Cause Action (Reference)
Route calculation wasnot
possible.
Route calculationhas failed be-
cause of amalfunction in mapdata,
software, or hardware.
! Change thedestination.
! Consultthe Pioneer Localdealer if thismes-
sage persists.
Route calculation notpossi-
ble. Destination toofar.
The destination istoo far. Set adestination closer to thestarting point.
Route calculation notpossi-
ble. Destination tooclose.
The destination istoo close. Set a destinationfarther from the starting
point.
Route calculation notpossi-
ble. Navigation cannotbe pro-
vided arounddestination or
starting point.
The destination,waypoint(s), or
starting point arein an areawhere
no road exists(e.g. amountain) and
the routecalculation isimpossible.
! Seta destination and waypoint(s)on roads.
! Resetthe destination after you drivethe ve-
hicle toany road.
Route todestination cannot
be calculated.
The destination orwaypoint(s) are in
an isolated island,etc. without a
ferry and the routecalculation is im-
possible. If thereis no roadcon-
nected toyour starting point or
destination, thismessage will ap-
pear.
Change thedestination.
Failed tocreate route profile In rare cases, aroute calculation
error may occur.
! Retry.
! Consultthe Pioneer Localdealer if thismes-
sage persists.
No picturefolder. Save jpeg
file to /Pictures/folder
Cannot loadthe image because
Picturesfolderis not foundin the
inserted external storagedevice.
Use appropriate dataand store itcorrectly.
(Page 99)
Picturesfolderexists on theSD
memor y card but thereis no load-
able data inthe folder.
Use appropriate dataand store itcorrectly.
(Page 99)
Data Readerror. Failed toread the datafor some rea-
son.
Use appropriate dataand store itcorrectly.
(Page 99)
The fileis corrupt The datais damaged or anattempt
was made toset animage file that
was notmade to specifications as
the splash screen.
Use appropriate dataand store itcorrectly.
(Page 99)
Appendix
En
182
Appendix