Pioneer AVIC-Z110BT GPS Receiver User Manual


 
Rear view camera
The navigation system features a function that
automatically switches to the full-screen rear
view camera image installed on your vehicle.
When the shift lever is in the REVERSE (R) po-
sition, the screen automatically switches to
full-screen rear view camera.
Camera for Rear view mode
[Rear View] can be displayed at all times (e.g.
when monitoring an attached trailer, etc.) as a
split screen where map information is partially
displayed. Please be aware that with this set-
ting, camera image is not resized to fit, and
that a portion of what is seen by the camera is
not viewable.
CAUTION
Pioneer recommends the use of a camera which
outputs mirror reversed images, otherwise the
screen image may appear reversed.
p Immediately verify whether the display
changes to a rear view camera image when
the shift lever is moved to REVERSE (R)
from another position.
p When the screen changes to full-screen
rear view camera image during normal
driving, switch to the opposite setting in
[Polarity].
1 Display the System Settings screen.
2 Touch [Back Camera].
The Back Camera Settingsscreen appears.
3 Touch [Camera] to turn it [On].
p You can only switch to Rear Viewif this
setting is [On].
4 Touch [Battery] or [GND] next to
Polarityto select the appropriate polarity
setting.
! BatteryWhen the polarity of the con-
nected lead is positive while the shift lever
is in the REVERSE (R) position
! GNDWhen the polarity of the connected
lead is negative while the shift lever is in
the REVERSE (R) position
Adjusting the response
positions of the touch panel
(touch panel calibration)
If you feel that the touch panel keys on the
screen deviate from the actual positions that
respond to your touch, adjust the response po-
sitions of the touch panel screen.
p Do not use a sharp pointed tool such as a
ballpoint pen or a mechanical pen, which
could damage the screen.
1 Display the System Settings screen.
2 Touch [Screen Calibration].
A message confirming whether to start the ca-
libration appears.
3 Gently touch the center of + mark dis-
played on the screen.
The target indicates the order.
After you touch all marks, the adjusted posi-
tion data is saved.
p Do not turn off the engine while saving the
adjusted position data.
# Press the MODE button.
Returns to the previous adjustment position.
# Press and hold the MODE button.
Cancels the adjustment.
Setting the illumination color
The illumination color can be selected from 11
different colors. Furthermore, the illumination
color can switched between these 11 colors in
order.
To set the illumination color, display the Illu-
mination Colorscreen.
1 Display the System Settings screen.
2 Touch [Illumi Color].
The Illumination Color screen appears.
Customizing preferences
En
100
Chapter
13