Filter
Top Products
3 Say “I need directions”.
A message prompting you to select a search
by address or by POI appears.
4 Say “Find an address”.
A message to prompt the next operation is
given.
5 Say a command according the message
displayed on the screen.
p When the list of candidates with number
appears, say the number that you want to
select.
When you select the entry next to “1”, say
“Number One”.
p If there are multiple items that correspond
to the name you gave, the list screen ap-
pears. In this case, touch the item you want
to select from the list.
Search for POI in vicinity
In this example, you want to search for a POI
and set it as your destination.
1 Press the MODE button to display the
map screen or the AV operation screen.
2 Press the VOICE button to activate
voice operations.
A list of commands for voice operation ap-
pears. Af ter the message, the beep indicates
that the system is ready to accept your voice
command. Say a command after this beep.
3 Say “I need directions”.
A message prompting you to select a search
by address or by POI appears.
4 Say “Point of interest”.
A message to prompt the next operation is
given.
5 Say a command according the message
displayed on the screen.
p When the list of candidates with number
appears, say the number that you want to
select.
When you select the entry next to “1”, say
“Number One”.
p If there are multiple items that correspond
to the name you gave, the list screen ap-
pears. In this case, touch the item you want
to select from the list.
Calling the entry on “Contacts”
A method for dialing the entry named “Nancy”
is described here along with an operational ex-
ample.
1 Press the VOICE button to activate
voice operations.
2 Say “Call Nancy” to make a call.
The message confirming whether to dial ap-
pears.
3 Say “Yes”.
Dialing starts.
Operating iPod by voice
You can play music using voice operation from
the iPod connected to the navigation system.
p To use the content/data on the iPod for
voice operation, transfer the data to this
system first.
= For details, refer to Acquiring/Cataloging
iPod music information on page 162.
Examples of voice operation of the iPod are
shown below. (A method for playing the album
title named “Pioneer” is described here, along
with an operational example.)
1 Press the VOICE button to activate
voice operations.
2 Say “Change Source” to display the AV
source selection screen.
3 Say “iPod” on the selection screen to
switch the AV source to iPod.
p Touchingthe item on the screen also en-
ables you to select the desired AV source.
4 Press the VOICE button to activate
voice operations.
5 Say “Play the album Pioneer” to play-
back the album name “Pioneer”.
If the command is recognized properly, play-
back starts from the first song of “Pioneer”.
Operating Your Navigation System with Voice
En
169
Chapter
33
Operating Your Navigation System with Voice