Filter
Top Products
(Continued)
0
Rotate tires. See “Tire Inspection and Rotation”
in
the Index for proper
rotation pattern and additional information. See “Tires” in the Index.
0
Check readfront axle fluid level and add fluid as needed. Check
constant velocity joints and axle seals for leaking.
**
60,000
Miles
(100
000
km)
0
Change engine oil and filter (or every
3
months, whichever occurs
0
Lubricate the front suspension, king pin bushings, steering linkage,
transmission shift linkage, transfer case shift linkage, parking brake
cable guides, rear driveline center splines, front axle propshaft splines,
brake pedal springs and clutch pedal springs. Ball joints and king pin
bushings should
not
be lubricated unless their temperature is
10”
F
(-12”
C),
or higher. When weather is cold, let the ball joints and king
pin bushings warm up before lubrication or they could be damaged.
Perform each
of
the listed lubrication service items at this mileage
interval (or every
12
months, whichever occurs first).
0
Drain, flush and refill the cooling system with new coolant (or every
24
months, whichever occurs first). See “Engine Coolant” in the Index for
what to use.
An Emission Control Service.
Also inspect the hoses and replace them if they are cracked, swollen or
deteriorated. Tighten all hose clamps (except constant tension clamps).
Remove debris and clean the outside of
the
radiator and air
conditioning condenser. Wash
the
radiator neck. To ensure proper
operation, pressure test
the
radiator and cap.
first).
An Emission Control Service.
(Continued)
7-90