Filter
Top Products
Maintenance Schedule
I
-
Gasoline Engines With
Light Duty Emissions
(Continued)
0
Check readfront axle fluid level and add fluid
as
needed. Check
constant velocity joints and axle seals for leaking.:'''':
0
For 2-Wheel Drive vehicles only: Clean and repack the front wheel
bearings (or at each brake relining, whichever occurs first).
I7
Inspect air cleaner filter
if
you
are driving
in
dusty conditions. Replace
filter if necessary.
An
Emission
Control
Sewice.
DATE
SERVICED
BY:
ACTUAL MILEAGE
48,000
Miles
(80
000
km)
0
Change engine oil and filter (or every
3
months, whichever occurs
first).
An
Emission
Control
Service.
0
Lubricate the front suspension, king pin bushings, steering linkage,
transmission shift linkage, transfer case shift linkage, parking brake
cable guides, rear driveline center splines, front axle propshaft splines,
brake pedal springs and clutch pedal springs. Ball joints and king pin
bushings should not be lubricated unless their temperature
is
10"
F
(-12"
C),
or higher. When weather
is
cold, let the ball joints and king
pin bushings warm up before lubrication or they could be damaged.
Perform each of the listed lubrication service items at this mileage
interval (or every
6
months, whichever occurs first).
0
Check readfront axle fluid level and add fluid
as
needed. Check
constant velocity joints and axle seals for leaking.**
I
DATE
I
ACTUALMILEAGE
I
SERVICED
BY:
7-23