Filter
Top Products
Maintenance Schedule
I
-
Gasoline Engines Heavy
Duty Emissions
36,000
Miles
(60
000
km)
0
0
0
0
0
0
0
0
Change engine oil and filter (or every
3
months, whichever occurs
first).
An Emission Control Service.
Lubricate the front suspension, king pin bushings, steering linkage,
transmission shift linkage, transfer case shift linkage, parking brake
cable guides, rear driveline center splines, front axle propshaft splines,
brake pedal springs and clutch pedal springs. Ball joints and king pin
bushings should not be lubricated unless their temperature is
10"
F
(-12" C), or higher. When weather is cold, let the ball joints and king
pin bushings warm up before lubrication or they could be damaged.
Perform each of the listed lubrication service items at this mileage
interval (or every 12 months, whichever occurs first).
Check readfront axle fluid level and add fluid as needed. Check
constant velocity joints and axle seals for leaking.**
For 2-Wheel Drive vehicles only: Clean and repack the front wheel
bearings (or at each brake relining, whichever occurs first).
Inspect air cleaner filter if you
are
driving in dusty conditions. Replace
filter if necessary.
An Emission
Control
Service.
Replace fuel filter. Replace filter sooner if it is clogged.?
Inspect accessory drive (serpentine) belt for cracks, fraying and wear
and check belt for proper tension. Adjust or replace belt as needed.
An
Emission Control Service.
Inspect shields and underhood insulation for damage or looseness.
Adjust or replace as required.
This is a Noise Emission Control
Service. Applicable only to vehicles sold in the United States.
If
your engine
has
a thermostatically controlled cooling
fan,
inspect all
hoses and ducts for proper hook-up (or every
12
months, whichever
occurs first). Be sure the valve works properly.
This is
a
Noise
Emission Control Service. Applicable only to vehicles sold in the
United States.
DATE ACTUAL MILEAGE SERVICED
BY
7-44
1