Filter
Top Products
Maintenance Schedule
I
-
Gasoline Engines With
Light Duty Emissions
(Continued)
0
Check readfront axle fluid level and add fluid as needed. Check
constant velocity joints and axle seals for leaking.*:$
I
DATE
I
ACTUALMILEAGE
I
SERVICED
BY:
I
60,000
Miles
(100
000
km)
0
Change engine
oil
and filter (or every
3
months, whichever occurs
first).
An
Emission
Control Service.
0
Lubricate the front suspension, king pin bushings, steering linkage,
transmission
shift
linkage, transfer case shift linkage, parking brake
cable guides, rear driveline center splines, front axle propshaft splines,
brake pedal springs and clutch pedal springs. Ball joints and king pin
bushings should
not
be lubricated unless their temperature is
10”
F
(-12”
C),
or higher. When weather
is
cold, let
the
ball joints and king
pin bushings warm up before lubrication or they could be damaged.
Perform each of the listed lubrication service items at this mileage
interval (or every
6
months, whichever occurs first).
17
Check readfront axle fluid level and add fluid
as
needed. Check
constant velocity joints and axle seals for leaking.**
0
For 2-Wheel Drive vehicles only: Clean and repack the front wheel
bearings (or at each brake relining, whichever occurs first).
0
Inspect engine accessory drive belt.
An
Emission Control Service.
0
Drain,
flush
and refill cooling system (or every 24 months, whichever
occurs first). See “Engine Coolant”
in
the Index for what to use.
Inspect hoses. Clean radiator, condenser, pressure cap and neck.
Pressure test the cooling system and pressure cap.
An
Emission Control
Service.
0
Replace spark plugs.
An
Emission Control Service.
(Continued)
7-26