Filter
Top Products
1
Maintenance Schedule
II
-
Diesel Engines
I
(Continued)
0
Inspect shields and underhood insulation for damage or looseness.
Adjust or replace
as
required.
This
is
a Noise Emission Control
Service. Applicable only to vehicles sold in the United States.
0
Check the air intake system installation to assure that gaskets are
properly sealed and that
all
hose connections, fasteners and other
components are tight.
Also
check
to
be sure that
the
air cleaner housing
is properly seated, the cover fits tightly and the wing nuts are tight.
Tighten connections and fasteners or replace damaged parts as
necessary.
This is
a
Noise Emission Control Service. Applicable only
to
vehicles
sold
in the United States.
0
If
your engine has a thermostatically controlled cooling fan, inspect all
hoses and ducts for proper hook-up (or every
12
months, whichever
occurs first).
Be
sure
the
valve works properly.
This
is
a Noise
Emission Control Service. Applicable only to vehicles sold in the
United States.
0
Check readfront axle fluid level and add fluid
as
needed. Check
constant velocity joints and axle seals for leaking.
**
DATE
SERVICED
BY:
ACTUAL
MILEAGE
55,000
Miles
(88
000
km)
0
Change engine oil and filter (or every
3
months, whichever occurs
first).
An
Emission Control Service.
0
Lubricate
the
front suspension, king pin bushings, steering linkage,
transmission shift linkage, transfer case shift linkage, parking brake
cable guides, rear driveline center splines, front axle propshaft splines,
brake pedal springs and clutch pedal springs.
Ball
joints and king pin
bushings should
not
be lubricated unless their temperature is
10"
F
(-12"
C),
or
higher. When weather
is
cold, let the ball joints and king
pin bushings warm up before lubrication or
they
could be damaged.
Perform each
of
the
listed lubrication service items at this mileage
interval (or every
12
months, whichever occurs first).
(Continued)
7-89