Filter
Top Products
FADE
-
Press lightly
on
the
FADE knob
to
release it from
its
stored
position and
pull
it
out
to
the
fully extended position. Rotate the knob
clockwise to adjust sound
to
the front speakers and counterclockwise to
adjust sound to the rear speakers. Push the knob back
in
to the stored
position when done.
BAL
-
Press lightly on
the
BAL
knob to release
it
from its stored position
and pull it
out
to the
fully
extended position. Rotate the knob clockwise to
adjust sound to the right speakers and counterclockwise to adjust sound
to
the left speakers. Push the knob back in to the stored position when done.
BASS
-
Press lightly
on
the BASS knob
to
release it from its stored
position and pull
it
out to the
fully
extended position. Rotate
the
knob
clockwise
to
increase the bass response and counterclockwise
to
decrease
bass response. Any time the BASS control is rotated,
tone
is automatically
set back to
MAN
(manual). Push the knob back
in
to the stored position
when done.
TREBLE
-
Press lightly
on
the TREB knob
to
release
it
from its stored
position and pull
it
out
to
the fully extended position. Rotate the knob
clockwise to increase the treble response and counterclockwise
to
decrease
treble response. Any time the TREB control is rotated,
tone
is
automatically
set back
to
MAN (manual). Push the knob back
in
to
the stored position
when done.
To
Play
a
Cassette
Your tape player is built to work best with tapes that are
30
to
45
minutes
long
on
each side. Tapes longer
than
that
are
so
thin they may not work well
in this player.
To
load
a
cassette tape with the ignition off, first press EJECT or RCL.
Then, insert the cassette tape.
Once the tape is playing, use the control knobs for volume, balance, fade,
treble and bass just
as
you do for the radio. A lighted tape symbol shows
when a cassette tape is in the player. A lighted arrow
will
also appear and
show the direction of play when a tape
is
active.
The player automatically senses if the cassette tape
is
metal or
CR02
and
adjusts for best playback sound. For metal tapes,
00
(Dolby' Noise
Reduction) will appear
in
the
display.
Any time
a
cassette tape is inserted, the top side is selected for play first.
PREV (1)
-
Press PREV or
4
SEEK
(in
the direction that the lighted tape
direction
arrow
points)
to
search for the previous selection.
A
minimum
three-second blank gap is needed for the player to stop at the beginning
of
the selection.
The
tape direction arrow will blink during the SEEK
operation.
3-16
..