Chevrolet STFF6S Automobile User Manual


 
The lap part
of
the belt should be worn low and snug on the hips, just
touching the thighs. In a crash, this applies force to the strong pelvic bones.
And you’d be less likely to slide under the lap belt. If you slid under it, the
belt would apply force
at
your abdomen. This could cause serious or even
fatal injuries. The shoulder belt should go over the shoulder and across the
chest. These parts of
the
body are best able to take belt restraining forces.
The safety belt locks if there’s a sudden stop
or
a crash.
Shoulder Belt Height Adjuster (&Door Utility Models)
Before you begin to drive, move the shoulder belt adjuster
to
the height that
is
right for you.
To move it down, push in at the word
PRESS
and move the height adjuster to
the desired position. You can move the adjuster up just
by
pushing up on the
shoulder belt guide. After you move the adjuster to where you want it,
try
to
move it down without pushing
in
to make sure it has locked into position.
Adjust the height
so
that the shoulder portion of the belt
is
centered on your
shoulder. The belt should be away from your face and neck, but not falling
off
your shoulder.
1-23