Filter
Top Products
Using Foam-Type Cleaner on Fabric
Vacuum and brush the area to remove any loose dirt.
Always clean
a
whole trim panel or section. Mask surrounding trim
along stitch or welt lines.
0
Mix
Multi-Purpose Powdered Cleaner following the directions
on
the
Use suds only and apply
with
a clean sponge.
Don’t saturate the material.
Don’t rub
it
roughly.
As
soon
as
you’ve cleaned the section, use
a
sponge
to
remove the
0
Rinse the section with a clean, wet sponge.
Wipe off what’s
left
with a slightly damp paper towel or cloth.
Then dry
it
immediately
with
a
blow dryer or a heat lamp.
container label.
suds.
NOTICE:
Be
careful.
A
blow dryer may scorch the fabric.
0
Wipe with a clean cloth.
Using Solvent-Type Cleaner
on
Fabric
First, see if
you
have to use solvent-type cleaner at all. Some spots and
stains will clean off better with
iust
water and mild
soap.
If you need to use
a
solvent:
Gently scrape excess soil from the trim material
with
a clean, dull knife
or scraper. Use very little cleaner, light pressure and clean cloths
(preferably cheesecloth). Cleaning should start at the outside of the
stain, “feathering” toward the center. Keep changing to
a
clean section
of
the cloth.
When you clean
a
stain from fabric, immediately dry the area with
a
blow dryer to
help
prevent
a
cleaning ring. (See the previous NOTICE.)
6-64