Filter
Top Products
I
Maintenance Schedule
II
-
Gasoline Engines With
Light Duty Emissions
30,000
Miles
(50
000
km)
0
0
0
0
0
0
0
Change engine oil and filter (or every 12 months, whichever occurs
first).
An Emission Control Service.
Lubricate the front suspension, king pin bushings, steering linkage,
transmission shift linkage, transfer case shift linkage, parking brake
cable guides, rear driveline center splines, front axle propshaft splines,
brake pedal springs and clutch pedal springs. Ball joints and king pin
bushings should
not
be lubricated unless their temperature is
10"
F
(-12"
C), or higher. When weather is cold,
let
the ball joints and king
pin bushings warm up before lubrication
or
they could be damaged.
Perform each
of
the listed lubrication service items at this mileage
interval (or every
12
months, whichever occurs first).
Check readfront axle
fluid
level and add fluid as needed. Check
constant velocity joints and axle seals for leaking.**
For 2-Wheel Drive vehicles only: Clean and repack the
front
wheel
bearings (or at each brake relining, whichever occurs first).
Drain,
flush
and refill cooling system (or every
24
months, whichever
occurs first). See "Engine Coolant" in the Index for what
to
use.
Inspect hoses. Clean radiator, condenser, pressure cap and neck.
Pressure test the cooling system and pressure cap.
An Emission Control
Service.
Replace spark plugs.
An Emission Control Service.
Replace air cleaner filter.
An
Emission Control Service.
I
DATE
I
ACTUALMILEAGE
I
SERVICED
BY: