Filter
Top Products
Maintenance Schedule
II
-
Diesel Engines
I
10,000
Miles
(16
000
km)
0
Change engine oil and filter (or every 12 months, whichever occurs
first).
An
Emission
Control
Service.
0
Lubricate the front suspension, king pin bushings, steering linkage,
transmission shift linkage, transfer case shift linkage, parking brake
cable guides, rear driveline center splines, front axle propshaft splines,
brake pedal springs and clutch pedal springs. Ball joints and king pin
bushings should
not
be lubricated unless their temperature is
10"
F
(-12"
C),
or higher. When weather is cold, let the ball joints and king
pin bushings warm up before lubrication or they could be damaged.
Perform each of
the
listed lubrication service items at this mileage
interval (or every 12 months, whichever occurs first).
0
Inspect shields and underhood insulation for damage or looseness.
Adjust
or
replace as required.
This is a Noise Emission Control
Service. Applicable only to vehicles sold in the United States.
0
Check the air intake system installation
to
assure
that
gaskets are
properly sealed and that all hose connections, fateners and other
components are tight. Also check
to
be sure that the air cleaner housing
is properly seated, the cover fits tightly and
the
wing nuts are tight.
Tighten connections and fasteners or replace damaged parts as
necessary.
This is a Noise Emission Control Service. Applicable only
to vehicles sold in the United States.
0
If your engine has a thermostatically controlled cooling fan, inspect all
hoses and ducts for proper hook-up (or every
12
months, whichever
occurs first). Be sure the valve works properly.
This is
a
Noise
Emission Control Service. Applicable only to vehicles sold in the
United States.
0
Check readfront axle fluid
level
and add fluid as needed. Check
constant velocity joints and axle seals for leaking.
**
DATE
SERVICED
BY:
ACTUAL
MILEAGE
L
7-81
-.