Filter
Top Products
Securely attach the harness to the trailer, then tape or strap it
to
your
vehicle’s frame rail.
Be
sure you leave it loose enough
so
the wiring won’t
bind or break when turning with the trailer, but not
so
loose that it drags on
the ground.
Store the harness in its original position. Wrap the harness together and tie it
neatly
so
it won’t be damaged.
If you do tow a trailer, your Center High Mount Stoplamp (CHMSL) may
not be properly visible from behind.
You
should select a trailer with a
CHMSL on it or, if one is not available, have one installed. See your GM
dealer about how to connect your vehicle’s wiring to a trailer CHMSL.
Step-Bumper
Pad
If
your vehicle has a rear step bumper, it may be equipped with a rear step
pad at the center
of
the bumper. Use this pad to improve footing when you
are stepping on the bumper step.
If
you will be using
the bumper to tow a
trailer, you must
remove the center
cutout circle
to
install
the trailer ball. You
must also remove both
outer cutouts to attach
the trailer safety
chains.
2-86