Filter
Top Products
Remote Cassette Player
-
€?W
AM-FM
Stereo
Audio
Compact
Disc
ATC
System
..
EJECT
i
1
If you have an
ETR@
AM-FM Stereo Audio
Compact Disc ATC
System that includes a
remote cassette player,
the cassette player is
located in the center
panel.
,
of the instrument
Your tape player is built
to
work best with tapes that are
30
to
45
minutes
long
on
each side. Tapes longer than that are
so
thin
they
may not work well
in
this player.
To
load a cassette tape with
the
ignition
off,
first press EJECT. Then, insert
the
cassette tape.
Once
the
tape is playing, use the control knobs for volume, balance, fade,
treble and bass just as you do for the radio. A lighted tape symbol shows
when a cassette tape is in the player. A lighted arrow will also appear and
show
the
direction of play when a tape
is
active.
The player automatically senses
if
the cassette tape is metal or CRO2 and
adjusts for best playback sound. For metal tapes,
00
(Dolby@ Noise
Reduction) will appear in the display.
Any time a cassette tape is inserted, the top side is selected for play first.
PREV
(1)
-
Press PREV or
4
SEEK
(in
the opposite direction that the
lighted tape direction arrow points) to search for the previous selection.
A
minimum three-second blank gap
is
needed for the player to stop at the
beginning
of
the selection. The tape direction arrow will blink during the
SEEK operation and
the
audio is
in
the mute mode.
PROG
(on
cassette player)
-
Press PROG to go from one side of
the
tape
to the other.
NEXT
(3)
-
Press NEXT or SEEK (in the direction that the lighted tape
direction arrow points) to search for the next selection. A minimum
three-second blank gap is needed for the player
to
stop
at
the beginning
of
the selection. NEXT will appear
in
the
display and the audio is
in
the mute
mode.
3-25
-