Filter
Top Products
RCL (Recall)
-
Press this button to change between the clock and the radio
station frequency displayed when the radio is on. Also, press this button to
display the time when the ignition is off.
TUNE
-
Press
lightly
on
the TUNE button
to
release
it
from
its
stored
position. Rotate
the
knob clockwise to increase frequency and
counterclockwise to decrease radio frequency. When done, press
the
knob
again to return
it
to its stored position.
Pushbuttons
-
The six pushbuttons
let
you return to favorite stations. To
set the pushbuttons for up to
18
favorite stations
(6
AM,
6
FM1 and
6
FM2):
1.
Tune in the desired station.
2.
Press AUTO TONE to select
the
best setting for the type
of
station
chosen.
3.
Press and hold one of
the
pushbuttons
until
sound returns
(approximately two seconds). Whenever you press
that
button, me
preset station will return.
Repeat these steps for each pushbutton.
SEEK
-
Press SEEK to cause the receiver to seek the next higher
station.
Press
4
SEEK to cause the receiver to seek the next lower station.
SCAN
-
Press and hold the center of the SEEK button to momentarily hear
each available station. Release the button when SCAN appears
in
the
display. The receiver will continue to scan and momentarily stop at each
station
until
you press the center
of
the
SEEK button again.
P. SCAN (Preset Scan)
-
Press this button to scan each preset pushbutton
station. The receiver will continue to scan and momentarily stop at each
station
until
you press either
P.
SCAN again or one of the six pushbuttons.
The AUTO SCAN setting for
that
preset button
will
also
return. The
pushbutton number (PI-P6)
will
appear momentarily just before frequency
is displayed.
AUTO TONE
-
Press this button to select between five preset equalization
settings and tailor the sound to
the
music or voice being heard. Each time
you press the button, the selection
will
switch
to
one
of
the preset settings of
CLASSIC, NEWS, ROCK, POP, or
JAZZ.
The display
will
show which
mode
the receiver
is
in.
To
return to the manual mode, press and release
AUTO TONE until
MAN
(manual) appears
in
the display. This will return
the tone adjustment to the TREB and BASS controls. Also, any time a
TREB or BASS control is rotated, tone is automatically set back to MAN
(manual).
3-15