Filter
Top Products
Setting the
Clock
(Audio Systems with AUTO
TONE
System)
The buttons used to set the clock are located below the AUTO TONE button
in the bottom right corner of your audio system.
To
set the clock:
1.
Press and hold HR until the correct hour appears
on
the display.
2.
Press and hold
MIN
until the correct minute appears on the display.
To display the clock with the ignition off, press the recall button. The time
will be displayed for a few seconds.
There is an initial two-second delay before the clock goes into the time-set
mode.
How
to Operate Your ETW AM-FM Stereo Audio
System
This part tells you.how your ETR@AM-FM stereo audio system works.
Upper Knob (VOL-RECALL)
-
The upper knob has these four functions:
Turn it
to
switch the system on and
off.
Turn it to control the volume.
Press it to display the time when the ignition is
off.
Press it to change between the clock and the radio station frequency
displayed when the radio is
on.
BAL (Balance)
-
The control ring behind the upper knob adjusts the
left/right speaker balance.
3-10