Filter
Top Products
I
Maintenance Schedule
II
-
Diesel Engines
(Continued)
0
0
0
Inspect shields and underhood insulation for damage or looseness.
Adjust or replace as required.
This
is
a Noise Emission Control
Service. Applicable only
to
vehicles sold in the United States.
Check the air intake system installation
to
assure that gaskets are
properly sealed and that all hose connections, fasteners and other
components are tight. Also check to
be
sure that the air cleaner housing
is
properly seated, the cover fits tightly and the wing nuts are tight.
Tighten connections and fasteners or replace damaged parts as
necessary.
This
is
a
Noise Emission Control Service. Applicable only
to vehicles sold in the United States.
If
your engine has a thermostatically controlled cooling fan, inspect all
hoses and ducts for proper hook-up (or every
12
months, whichever
occurs first). Be sure the valve works properly.
This
is
a Noise
Emission Control Service. Applicable only to vehicles sold in the
United States.
Check readfront axle fluid level and add fluid
as
needed. Check
constant velocity joints and axle seals for leaking.
**
DATE
ACTUAL
MILEAGE SERVICED
BY:
L
L
L
45,000
Miles
(72
000
km)
0
Change engine oil and filter (or every
3
months, whichever occurs
first).
An Emission
Control
Service.
0
Lubricate the front suspension, king pin bushings, steering linkage,
transmission shift linkage, transfer case shift linkage, parking brake
cable guides, rear driveline center splines, front axle propshaft splines,
brake pedal springs and clutch pedal springs. Ball
joints
and king pin
bushings should
not
be lubricated
unless
their temperature is
10"
F
(-12"
C),
or higher. When weather
is
cold, let the ball joints and king
pin bushings warm up before lubrication or they could be damaged.
Perform each of the listed lubrication service items at this mileage
interval
(or
every
12
months, whichever occurs first).
(Continued)
7-87