Filter
Top Products
3 - 36
INSP
ADJ
TIRE INSPECTION
1.Measure:
● Tire pressure (cold tire pressure)
Out of specification → Adjust.
NOTE:
● The Low-pressure tire gauge 1 is
included in the standard equipment.
● If dust or the like is stuck to this gauge, it
does not provide correct readings. There-
fore, make two measurements on the tire
pressure and get the second reading.
WARNING
Uneven or improper tire pressure may
adversely affect the handling of this
machine and may cause loss of control.
● Maintain proper tire pressures.
● Set tire pressures when the tires are cold.
● Tire pressures must be equal in both front
tires and equal in both rear tires.
2.Inspect:
● Tire surfaces
Wear/Damage → Replace.
WARNING
It is dangerous to ride with a wornout tire.
When a tire wear is out of specification,
replace the tire immediately.
Cold tire
pressure
Front rear
Standard
20 kPa
(0.20 kgf/cm
2
,
2.9 psi)
25 kPa
(0.25 kgf/cm
2
,
3.6 psi)
Minimum
17 kPa
(0.17 kgf/cm
2
,
2.5 psi)
22 kPa
(0.22 kgf/cm
2
,
3.2 psi)
Maximum
23 kPa
(0.23 kgf/cm
2
,
3.3 psi)
28 kPa
(0.28 kgf/cm
2
,
4.0 psi)
Tire wear limit a:
front and rear: 2.0 mm (0.08 in)
3