Filter
Top Products
8 - 15
–+
ELEC
ELECTRIC STARTING SYSTEM
C0NTINUITY
MOVES
3.Starter motor
● Connect the battery positive terminal 1
and starter motor cable 2 using a
jumper lead 3 .
● Check the operation of the starter motor.
*
*
1
M
2
3
R
L/W
B
WARNING
● A wire that is used as a jumper lead must
have the equivalent capacity or more as
that of the battery lead, otherwise the
jumper lead may burn.
● This check is likely to produce sparks, so
be sure that no flammable gas or fluid is
in the vicinity.
*
4.Starting circuit cut-off relay
● Remove the starting circuit cut-off relay
from the wire harness.
● Connect the pocket tester (Ω × 1) and the
battery (12V) to the starting circuit cut-
off relay terminals.
Battery (+) terminal →
Red/White terminal 1
Battery (–) terminal →
Green/Yellow terminal 2
Tester (+) lead → Red/White terminal 1
Tester (–) lead → Blue/White terminal 3
G/Y
Sb
L/W
R/W
2
1
3
CONTINUITY
● Check the starting circuit cut-off relay for
continuity.
*
NO CONTINUITY
Replace the starting circuit cut-off relay.
DOES NOT TURN
Repair or replace the starter motor.
8