Filter
Top Products
6 - 35
DRIV
FINAL DRIVE GEAR AND DRIVE SHAFT
ASSEMBLY
Reverse the “DISASSEMBLY” procedures.
Note the following points.
1.Install:
● Roller bearing (drive pinion gear)
*********************************
Installation steps:
●Heat the main housing only to 150˚C (302˚F)
●Install the roller bearing outer race using
the proper adapted.
●Install the inner race onto the drive shaft.
*********************************
2.Install:
● Oil seal 1
● Roller bearing 2 (outer race)
Use a suitable press tool 3 and a press to
install the above components into the
main housing.
WARNING
Always use a new oil seal.
3.Install:
● Drive pinion gear 1 (with shim(s) 2 and
bearing 3)
Shim(s) → (proper size as calculated)
● Bearing retainer 4 (drive pinion gear)
NOTE:
● The bearing retainer has left-hand
threads; turn retainer counterclockwise to
tighten it.
● Before installing the bearing retainer,
apply the grease to the O-ring.
● When installing the bearing retainer, use
the Bearing Retainer Wrench 1.
Bearing retainer wrench:
P/N. YM-04050, 90890-04050
T
R
.
.
Bearing retainer:
100 Nm (10.0 m • kg, 72 ft • lb)
6