Filter
Top Products
6 - 5
DRIV
MIDDLE GEAR SERVICE
3.Remove:
● Bearing retainers 1
Use a #40 Torx Driver.
4.Remove:
● Bearing 1
● Shim 2
DISASSEMBLY
Middle driven shaft
1.Remove:
● Universal joint
*********************************
Removal steps:
●Remove the circlips 1.
●Place the U-joint in a press.
●With a suitable diameter pipe beneath the
yoke, press the bearing into the pipe as
shown.
NOTE:
It may be necessary to lightly tap the yoke
with a punch.
●Repeat the steps for the opposite bearing.
●Remove the yoke and U-joint 2.
NOTE:
It may be necessary to lightly tap the yoke
with a punch.
*********************************
2.Remove:
● Nut 1 (U-joint)
● Washer 2
● U-joint 3
NOTE:
Hold the U-joint 3 by the Universal Joint
Holder 4 and Attachment 5 to loosen the nut.
6