Filter
Top Products
4 - 7
ENG
ENGINE DISASSEMBLY
8.Remove:
● Bolt 1
● Cam sprocket 2
NOTE:
● Fasten a safety wire 3 to the timing chain
to prevent if from falling into the crank-
case.
● When removing the cam sprocket, it is not
necessary to separate the timing chain.
● Hold the starter pulley 4 by the Rotor
Holder to loosen the bolt on the cam
sprocket.
Rotor holder:
P/N. YU-01235, 90890-01235
9.Remove:
● Bolts (cylinder head)
NOTE:
● Loosen the bolts 1/4 turn each and
remove them after all are loosened.
● Loosen the bolts starting with the highest
numbered one.
● The embossed numbers in the cylinder
head designate the tightening sequence.
10.Remove:
● Cylinder head assembly 1
● Gasket 2 (cylinder head)
● Dowel pins 3
● Oil seal 4
● Chain guide 5 (exhaust)
4