Filter
Top Products
– 13 –
SPEC
CABLE ROUTING
Ï Fasten the battery breather hose to the rear
fender with the plastic clamp and then insert the
clamp into the hole in the rear fender.
Ì Fasten the battery + lead and starter motor lead
to the rear fender with the plastic clamps.
Ó Install the starter circuit cut-off relay onto the tab
with its terminal side facing down.
È Route the throttle cable and rear brake cable
through the cable guide. Make sure that the
throttle cable is routed to the inside of the rear
brake cable.
Ô Make sure that the grommet is installed with the
mark facing forward.
Route the taillight lead through the lead holders
on the lid and the bottom of the box.
Ò 50 mm (2.0 in)
˜ 5 mm (0.2 in)