Filter
Top Products
– 9 –
SPEC
1
Rectifier/regulator
2
CDI unit
3
Starting circuit cut-off relay lead
4
Starter relay lead
5
Starter motor lead
6
Starting circuit cut-off relay
7
Starter relay
8
Rear brake breather hose
9
Carburetor air vent hose
0
Final gear case breather hose
È
Fasten the battery
+
lead and starter motor lead
to the rear fender with the plastic clamps.
É
Install the starter circuit cut-off relay onto the tab
with its terminal side facing down.
Ê
Fasten the wire harness and starter motor lead
to the frame with the plastic locking tie.
Ë
Install the starter relay onto the tabs with its ter-
minal side facing up.
Ì
Fasten the battery breather hose to the rear
fender with the plastic clamp and then insert the
clamp into the hole in the rear fender.
CABLE ROUTING