Filter
Top Products
8 - 10
–+
ELEC
IGNITION SYSTEM
C0NTINUITY
4.Ignition coil resistance
● Disconnect the ignition coil connector
from the wire harness.
● Connect the pocket tester (Ω × 1) to the
ignition coil.
*
Tester (+) lead → Orange lead terminal
Tester (–) lead → Ignition coil base
Tester (+) lead → Ignition coil base
Tester (–) lead → Spark plug lead
● Check that the primary coil has the spec-
ified resistance.
Primary coil resistance:
0.18 ~ 0.28 Ω at 20 ˚C (68˚F)
● Connect the pocket tester (Ω × 1k) to the
ignition coil.
BOTH MEET
SPECIFICATION
● Check that the secondary coil has the
specified resistance.
Secondary coil resistance:
6.3 ~ 9.5 kΩ at 20 ˚C (68˚F)
OUT OF SPECIFICATION
Replace the ignition coil.
CORRECT
5.Engine stop switch
Refer to “SWITCH INSPECTION”.
INCORRECT
Replace the handlebar switch (left).
CORRECT
6.Main switch
Refer to “SWITCH INSPECTION”.
*
INCORRECT
Replace the main switch.
8