7 - 39
CHAS
REAR SHOCK ABSORBER AND SWINGARM
2.Inspect:
● Swingarm
Cracks/Bends/Damage → Replace.
● Axle housing
Cracks/Bends/Damage → Replace.
3.Inspect:
● Final gear case under cover
Cracks/Bends/Damage → Replace.
4.Inspect:
● Pivot shaft 1 (right side)
● Pivot shaft 2 (left side)
● Spacer collar 3
Wear/Damage → Replace.
5.Inspect:
● Bearings 1 (swingarm)
Bearings allow play in the swingarm or to
the bearing turns roughly → Replace.
● Oil seals 2
Wear/Damage → Replace.
*********************************
Swingarm bearing and oil seal replacement
steps:
●Clean the area around the bearings on the
swingarm.
●Remove the oil seals 1 use a flat-head
screw driver.
NOTE:
Place a wood block 2 on the outer edge to
protect this edge.
7