7 - 40
CHAS
REAR SHOCK ABSORBER AND SWINGARM
●Remove the bearings 3 using a general
bearing puller.
●Install the new bearings and oil seal by
reversing the previous steps.
NOTE:
Use a socket 4 that matches the outside
diameter of the race of the bearing and oil
seal.
CAUTION:
Do not strike the center race 5 or balls 6
of the bearing. Contact should be made
only with the outer race 7.
*********************************
INSTALLATION
Reverse the “REMOVAL” procedures.
Note the following points.
1.Lubricate:
● Bearings 1
● Oil seals 2
● Collars 3
● Pivot shafts 4
Lithium-soap base grease
2.Install:
● Swingarm
● Rear axle housing
● Pivot shafts (swingarm)
7