Filter
Top Products
2 - 29
SPEC
CABLE ROUTING
1 Wire harness
2 Starter motor lead
3 Rear brake cable
4 Throttle cable
5 Starter relay
6 Starting circuit cut-off relay
7 Rear brake breather hose
8 Carburetor air vent hose
9 Final gear case breather hose
0 Taillight lead
Å 50 mm (2.0 in)
ı Route the throttle cable and rear brake cable through the
cable guide. Make sure that the throttle cable is routed to the
inside of the rear brake cable.
Ç Install the starter relay onto the tabs with its terminal side
facing down.
Î Fasten the battery breather hose with the plastic clamp and
then insert the clamp into the hole in the rear fender.
‰ Install the starter circuit cut-off relay onto the tab with its ter-
minal side facing down.
Ï Make sure that the grommet is installed with the mark facing
forward.
Ì Route the taillight lead through the lead holders on the lid
and the bottom of the box.
2